2011-2013 Land Cruiser · Service Manual Drivetrain

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011

NOTICE:
Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.


1. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER ASSEMBLY

  1. C175286E01
    Place matchmarks on the flange yoke and sleeve yoke or propeller shaft.

  1. C175287
    Using a brass bar and hammer, slightly tap in the spider bearing outer races.

  1. Using 2 screwdrivers, remove the 4 snap rings from the grooves.

  1. C175288E01
    Using SST, push out the bearing from the flange.
    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.

  1. C115614
    Clamp the bearing outer race in a vise and tap off the flange with a hammer.

    HINT:
    Remove the bearing on the opposite side using the same procedure.

  1. Remove the flange yoke from the sleeve yoke (or propeller shaft).

  1. Install the 2 removed bearing outer races to the spider.

  1. C175293E01
    Using SST, push out the bearing from the yoke.
    SST
    09332-25010  

  1. Clamp the outer bearing race in a vise and tap off the yoke with a hammer.

    HINT:
    Remove the bearing on the opposite side using the same procedure.

← REMOVAL (from Sep 2011)INSPECTION (from Sep 2011) →