INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT REAR PROPELLER SHAFT ASSEMBLY |
Using a dial indicator, measure the propeller shaft runout.

- Maximum runout:
- 0.8 mm (0.031 in.)
| INSPECT SPIDER BEARING |
![]() ![]() |
- NOTICE:
- Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.
Check the spider bearings for wear or damage.
Check the axial play of each spider bearing by turning the yoke while holding the shaft tightly.
- Maximum bearing axial play:
- 0 mm (0 in.)

