2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. REMOVE ROOF HEADLINING ASSEMBLY (w/o Sliding Roof)
  1. Remove the roof headlining (Click here).


2. REMOVE ROOF HEADLINING ASSEMBLY (w/ Sliding Roof)
  1. Remove the roof headlining (Click here).


3. REMOVE QUARTER WINDOW ASSEMBLY

B180608E01

HINT:
Apply protective tape to the outer surface of the vehicle body to prevent scratches.

NOTICE:
When separating the quarter window glass from the vehicle, be careful not to damage the vehicle paint or interior/exterior ornaments.

  1. Disconnect the connectors.

  1. From the interior, insert a piano wire between the vehicle body and the quarter window glass as shown in the illustration.

  1. Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.

  1. Cut through the adhesive by pulling the piano wire around the quarter window glass.

    NOTICE:
    Leave as much adhesive on the vehicle body as possible when removing the quarter window glass.

  1. Using suction cups, remove the quarter window glass.


4. CLEAN VEHICLE BODY

B106081E09
  1. Clean and shape the contact surface of the vehicle body.

    1. On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.

      HINT:
      Leave as much adhesive on the vehicle body as possible.

      NOTICE:
      Be careful not to damage the vehicle body.

    2. Clean the contact surface of the vehicle body with cleaner.

      HINT:
      Even if all the adhesive has been removed, clean the vehicle body.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →