REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 3.
REMOVE SKID CONTROL SENSOR WIRE |
 |
- Disconnect the speed sensor LH connector.
Detach the 2 clamps and remove the bolt and sensor clamp.


Detach the 5 clamps.


Detach the 3 clamps.


- Disconnect the speed sensor RH connector.
- Remove the bolt.
- Disconnect the connector, and remove the bolt and skid control sensor wire.
| 4.
REMOVE REAR SPEED SENSOR LH |
 |
- Remove the nut and speed sensor.
- NOTICE:
- Pull out the sensor while trying as much as possible not to rotate it.
| 5.
REMOVE REAR SPEED SENSOR RH |
 |
- Remove the nut and speed sensor.
- NOTICE:
- Pull out the sensor while trying as much as possible not to rotate it.