2011-2013 Land Cruiser · Service Manual Brake

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE REAR WHEEL

4. REMOVE SKID CONTROL SENSOR WIRE

  1. C170899
    Disconnect the speed sensor LH connector.

  1. Detach the 2 clamps and remove the bolt and sensor clamp.

    C170896E01

  1. Detach the 5 clamps.

    C170897

  1. Detach the 3 clamps.

    C170898

  1. C170895
    Disconnect the speed sensor RH connector.

  1. C170900E01
    Remove the bolt.

  1. C170901E01
    Disconnect the connector, and remove the bolt and skid control sensor wire.


5. REMOVE REAR SPEED SENSOR LH

  1. C170903
    Remove the nut and speed sensor.

    NOTICE:
    Pull out the sensor while trying as much as possible not to rotate it.


6. REMOVE REAR SPEED SENSOR RH

  1. C170902
    Remove the nut and speed sensor.

    NOTICE:
    Pull out the sensor while trying as much as possible not to rotate it.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →