REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 3.
REMOVE FRONT SKID CONTROL SENSOR WIRE LH |
 |
- Disconnect the connector from the front speed sensor.
Remove the bolt and harness clamp.
Remove the nut and harness clamp.
- Remove the 2 bolts and 2 harness clamps.
- w/o AHC:
Disconnect the connector and then remove the bolt, harness clamp and sensor wire.
- w/ AHC:
Disconnect the 2 connectors and then remove the bolt, harness clamp and sensor wire.
| 4.
REMOVE FRONT SPEED SENSOR LH |
 |
- Remove the bolt and speed sensor from the knuckle.
- NOTICE:
- Pull out the sensor while trying as much as possible not to rotate it.
| 5.
REMOVE FRONT SKID CONTROL SENSOR WIRE RH |
 |
- Disconnect the connector from the front speed sensor.
Remove the bolt and harness clamp.
Remove the nut and harness clamp.
w/o AHC:
- Disconnect the connector.
Detach the connector from the skid control sensor clamp.
Remove the bolt and skid control sensor clamp.
Remove the 2 bolts, 2 harness clamps and sensor wire.
w/ AHC:
- Disconnect the connector.
Detach the connector from the skid control sensor clamp.
Remove the bolt and skid control sensor clamp.
Remove the 2 bolts and 2 harness clamps.
- Disconnect the connector and then remove the bolt, harness clamp and sensor wire.
| 6.
REMOVE FRONT SPEED SENSOR RH |
 |
- Remove the bolt and speed sensor from the knuckle.
- NOTICE:
- Pull out the sensor while trying as much as possible not to rotate it.