2011-2013 Land Cruiser · Service Manual Brake

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE FRONT WHEEL

4. REMOVE FRONT SKID CONTROL SENSOR WIRE LH

  1. C177132
    Disconnect the connector from the front speed sensor.

  1. Remove the bolt and harness clamp.

  1. Remove the nut and harness clamp.

  1. C170882
    Remove the 2 bolts and 2 harness clamps.

  1. C170883E01
    w/o AHC:
    Disconnect the connector and then remove the bolt, harness clamp and sensor wire.

  1. C170884E01
    w/ AHC:
    Disconnect the 2 connectors and then remove the bolt, harness clamp and sensor wire.


5. REMOVE FRONT SPEED SENSOR LH

  1. C271342
    Remove the bolt and speed sensor from the knuckle.

    NOTICE:
    Pull out the sensor while trying as much as possible not to rotate it.


6. REMOVE FRONT SKID CONTROL SENSOR WIRE RH

  1. C177133
    Disconnect the connector from the front speed sensor.

  1. Remove the bolt and harness clamp.

  1. Remove the nut and harness clamp.

  1. w/o AHC:

    1. C172203
      Disconnect the connector.

    2. Detach the connector from the skid control sensor clamp.

    3. Remove the bolt and skid control sensor clamp.

    4. Remove the 2 bolts, 2 harness clamps and sensor wire.

  1. w/ AHC:

    1. C170887
      Disconnect the connector.

    2. Detach the connector from the skid control sensor clamp.

    3. Remove the bolt and skid control sensor clamp.

    4. Remove the 2 bolts and 2 harness clamps.

    5. C170888
      Disconnect the connector and then remove the bolt, harness clamp and sensor wire.


7. REMOVE FRONT SPEED SENSOR RH

  1. C271343
    Remove the bolt and speed sensor from the knuckle.

    NOTICE:
    Pull out the sensor while trying as much as possible not to rotate it.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →