2011-2013 Land Cruiser · Service Manual Suspension

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use these procedures to troubleshoot the active height control suspension.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK FOR DTC*
    1. Check for DTCs (Click here).

    2. Clear the DTCs.

    3. Recheck for DTCs.

      Result 
      Result
      Proceed to
      DTC is not output
      A
      CAN DTC is output
      B
      DTC is output
      C


    B.

    C.
    A

    4.PROBLEM SYMPTOMS TABLE*
      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B

    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).

    NEXT

    6.ADJUST, REPAIR OR REPLACE*
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Sep 2011 – Dec 2011)INITIALIZATION (Sep 2011 – Dec 2011) →