2011-2013 Land Cruiser · Service Manual Suspension

C1756 Suspension Control Relay Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This relay is to supply the power source to the pump and motor. The relay stays on while the height control is operated.
DTC Code
Detection Condition
Trouble Area
C1756
When either of the following is detected:
  1. With the suspension control relay not activated, an open signal of the suspension control relay is detected for 1 second or more.
  2. With the suspension control relay activated, a short signal of the suspension control relay is detected 8 times successively.
  1. Harness or connector
  2. Suspension control relay
  3. Suspension control ECU

WIRING DIAGRAM

C165721E03

INSPECTION PROCEDURE

NOTICE:
  1. Before performing troubleshooting, inspect the connectors of related circuits.
  2. If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).


1. INSPECT SUSPENSION CONTROL RELAY (AHC)
  1. Remove the suspension control relay from the engine room relay block.

  1. C149624E03
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied to terminal 1 and 2
    10 kΩ or higher
    Battery voltage is applied to terminal 1 and 2
    Below 1 Ω



NG
REPLACE SUSPENSION CONTROL RELAY
OK


2. CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - RELAY BLOCK AND BODY GROUND)
C176974E01
  1. Remove the suspension control relay from the engine room relay block.

  1. Disconnect the K36 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K36-16 (RC) - Relay block suspension control relay terminal 1
    Always
    Below 1 Ω
    K36-16 (RC) - Body ground
    Always
    10 kΩ or higher
    Relay block suspension control relay terminal 2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU (Click here)


← C1741 Front Height Control Solenoid Valve RH Circuit Malfunction (+ 6 more codes) (from Jan 2012)C1756 Suspension Control Relay Malfunction (from Jan 2012) →