2011-2013 Land Cruiser · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Sep 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
  1. Remove the tonneau cover.


3. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (except Face to Face Seat Type)
  1. Remove the rear No. 2 seat assembly LH (Click here).


4. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (except Face to Face Seat Type)

HINT:
Use the same procedures described for the LH side.


5. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Face to Face Seat Type)
  1. Remove the rear No. 2 seat assembly LH (Click here).


6. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (for Face to Face Seat Type)

HINT:
Use the same procedures described for the LH side.


7. REMOVE REAR STEP COVER

B181673

HINT:
Use the same procedure to remove the step cover on the other side.

  1. Detach the 2 claws and remove the step cover.


8. REMOVE REAR DOOR SCUFF PLATE LH

B181674
  1. Remove the screw.

  1. Detach the 3 claws and 4 clips, and remove the scuff plate.


9. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

B181672
  1. Detach the 6 clips and remove the support plate.


10. REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)

B186439

HINT:
Use the same procedure to remove the tonneau cover holder cap on the other side.

  1. Detach the 2 claws and remove the tonneau cover holder cap.


11. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

B190187E01

HINT:
Use the same procedure to remove the rear seat cover cap on the other side.

  1. Using a screwdriver, detach the 3 claws and remove the rear seat cover cap.

    HINT:
    Tape the screwdriver tip before use.


12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

B182411
  1. w/ Rear Heater:
    Remove the 8 screws and duct.

  1. B182412
    Remove the 7 screws.

  1. Detach the 4 claws and remove the quarter trim cover.


13. REMOVE REAR SIDE NO. 2 AIR DUCT (w/ Heater)

E154788
  1. Remove the 3 screws and duct.


14. REMOVE SUSPENSION CONTROL ECU

  1. C172944
    Detach the wire harness clamp and disconnect the connector.

  1. Remove the 2 bolts and ECU.

← COMPONENTS (from Sep 2011)INSTALLATION (from Sep 2011) →