C1766 Height Control Pump Motor Current
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
In case that the height control has not finished in spite of performing the raise control for a certain period of time, the ECU interrupts the height control.| DTC Code |
Detection Condition |
Trouble Area |
| C1766 |
When the height control pump and motor operates continuously for 135 seconds. |
|
INSPECTION PROCEDURE
- NOTICE:
- If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).
- When the cargo weight is extremely heavy, this DTC may be stored.
- If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).
| 1. INSPECT FOR FLUID LEAK |
Inspect for fluid leaks (Click here).
|
|
||||
| OK | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (LEVELING VALVE, ACCUMULATOR VALVE AND GATE VALVE) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester on.
Select the Active Test mode on the intelligent tester.
Check the operation of the leveling valve solenoid, accumulator valve solenoid and gate valve solenoid when operating the solenoid with the intelligent tester.
AHC Tester Display
Test Part
Control Range
Diagnostic Note
Front Right Height Solenoid
Front height control solenoid valve RH
ON or OFF
Operation of solenoid can be heard.
Front Left Height Solenoid
Front height control solenoid valve LH
ON or OFF
Operation of solenoid can be heard.
Rear Right Height Solenoid
Rear height control solenoid valve RH
ON or OFF
Operation of solenoid can be heard.
Rear Left Height Solenoid
Rear height control solenoid valve LH
ON or OFF
Operation of solenoid can be heard.
Accumulator Valve
Accumulator solenoid valve
ON or OFF
Operation of solenoid can be heard.
Front Gate Valve
Front gate solenoid valve
ON or OFF
When the Front Gate Valve item of the Active Test is operated, the Front Gate Valve item of the Data List changes to ON/OFF.
Rear Gate Valve
Rear gate solenoid valve
ON or OFF
When the Rear Gate Valve item of the Active Test is operated, the Rear Gate Valve item of the Data List changes to ON/OFF.
- OK:
- The leveling valve solenoid, accumulator valve solenoid and/or gate valve solenoid operates.
|
|
||||
| OK | |
| 3. INSPECT SUSPENSION CONTROL RELAY (AHC) |
Remove the suspension control relay from the engine room relay block.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 5
Battery voltage is not applied to terminal 1 and 2
10 kΩ or higher
Battery voltage is applied to terminal 1 and 2
Below 1 Ω
|
|
||||
| OK | |
| 4. CHECK HEIGHT CONTROL PUMP AND MOTOR |
Remove the height control pump and motor (Click here).
Inspect if the compressor is stuck.
Apply battery voltage to the compressor motor and check the operation of the motor.

- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
Motor operates
- NOTICE:
- Do not allow the motor to operate for 60 seconds or more.
- If the height control pump and motor is shorted, locked, or has a similar type of malfunction, a large amount of current will be flowing. Therefore, if the motor does not operate, immediately stop this inspection.
- Do not allow the motor to operate for 60 seconds or more.
|
|
||||
| OK | |
| 5. INSPECT FLUID LINE |
Check if the fluid line is clogged.
- HINT:
- Check if the fluid line that connects the height control pump and motor and No. 1 height control valve is clogged. If it is not clogged, there probably is foreign matter clogging the interior of the No. 1 height control valve.
- Follow the removal and installation procedures for each part, as all parts need to be removed.
- Check if the fluid line that connects the height control pump and motor and No. 1 height control valve is clogged. If it is not clogged, there probably is foreign matter clogging the interior of the No. 1 height control valve.
|
|
||||
| OK | ||
| ||
