CHECK FOR INTERMITTENT PROBLEMS
Troubleshooting · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| CHECK FOR INTERMITTENT PROBLEMS |
- HINT:
- A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be monitored using the ECU data monitor function of the intelligent tester.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
Select areas where momentary interruption should be monitored.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
FR Speed Open
Front speed sensor RH open detection/Error or Normal
Error: Momentary interruption
Normal: Normal
-
FL Speed Open
Front speed sensor LH open detection/Error or Normal
Error: Momentary interruption
Normal: Normal
-
RR Speed Open
Rear speed sensor RH open detection/Error or Normal
Error: Momentary interruption
Normal: Normal
-
RL Speed Open
Rear speed sensor LH open detection/Error or Normal
Error: Momentary interruption
Normal: Normal
-
EFI Communication Open
ECM communication open detection/Error or Normal
Error: Momentary interruption
Normal: Normal
-
- HINT:
- A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
- If the Error display remains on, check the continuity between the ECU and the sensors, or between ECUs.
-
The Error display remains on for 1 second after the harness signal changes from momentary interruption (open circuit) to normal condition.

- A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs. If the display changes, the connector and/or wire harness is in momentary interruption (open circuit). Repair or replace the connector and/or wire harness, as one of them is faulty.
