CHECK FOR INTERMITTENT PROBLEMS
Troubleshooting · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| DESCRIPTION |
- HINT:
- A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected through the ECU data monitor function of the GTS.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
Select areas where momentary interruptions should be monitored.
- HINT:
- A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
- If Error is displayed, check for continuity between the ECUs and the sensors or between ECUs.
- Error remains displayed on the GTS for 1 second after the harness signal changes from a momentary interruption (open circuit) to normal.
- A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
FR Speed Open
Front speed sensor RH open circuit detection/
Error or Normal
Normal
-
FL Speed Open
Front speed sensor LH open circuit detection/
Error or Normal
Normal
-
RR Speed Open
Rear speed sensor RH open circuit detection/
Error or Normal
Normal
-
RL Speed Open
Rear speed sensor LH open circuit detection/
Error or Normal
Normal
-
EFI Communication Open
ECM communication open circuit detection/
Error or Normal
Normal
-
Deceleration Open
Acceleration sensor open circuit detection/
Error or Normal
Normal
-
Master Cylinder Open
Master cylinder pressure sensor open circuit detection/
Error or Normal
Normal
-
IG Voltage Value Decreased
IG voltage value decreased detection/
Error or Normal
Normal
-
IG Voltage Value Increased
IG voltage value increased detection/
Error or Normal
Normal
-
FR Speed Sensor Voltage Open
Front speed sensor RH voltage open circuit detection/
Error or Normal
Normal
-
FL Speed Sensor Voltage Open
Front speed sensor LH voltage open circuit detection/
Error or Normal
Normal
-
RR Speed Sensor Voltage Open
Rear speed sensor RH voltage open circuit detection/
Error or Normal
Normal
-
RL Speed Sensor Voltage Open
Rear speed sensor LH voltage open circuit detection/
Error or Normal
Normal
-
M/C Pressure Sensor Noise
Master cylinder pressure sensor noise detection/
Error or Normal
Normal
-
EFI Communication Invalid
ECM communication invalid detection/
Error or Normal
Normal
-
While observing the screen, gently jiggle the connectors or wire harnesses between the ECUs and sensors or between ECUs.
- OK:
- Normal display appears.
- NOTICE:
- The connector and/or wire harness has a momentary interruption (open circuit) if the display changes. Repair or replace the connectors and/or wire harnesses as one of them is faulty.