2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2012


CHECK DIFFERENTIAL PRESSURE SENSOR ASSEMBLY
  1. Connect the GTS to the DLC3.

  1. Turn the engine switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / DPNR Differential Pressure.

  1. for Bank 1:
    Disconnect the No. 1 air hose from the differential pressure sensor.

  1. for Bank 2:
    Disconnect the No. 3 air hose from the differential pressure sensor.

  1. Using SST, apply pressure to the differential pressure sensor.

    SST
    09992-00242  

    A271317E01
    Text in Illustration 
    *A
    for Bank 1
    *B
    for Bank 2
    V100135
    Pressure
    V100136
    Front of the Vehicle

  1. Check the pressure value of the sensor.

    Standard pressure:
    Approximately the same pressure as the applied pressure is indicated on the tester.

    HINT:
    Perform the inspection by applying a pressure within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).

    If the result is not as specified, check the sensor circuit (Click here).

  1. for Bank 1:
    Connect the No. 1 air hose to the differential pressure sensor.

  1. for Bank 2:
    Connect the No. 3 air hose to the differential pressure sensor.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →