2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Jan 2012


1. REMOVE DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

  1. for Bank 1:

    1. A271239
      Disconnect the differential pressure sensor connector.

    2. Disconnect the No. 1 air hose and No. 2 air hose.

    3. Remove the bolt and sensor bracket.

    4. Remove the bolt and differential pressure sensor from the sensor bracket.

  1. for Bank 2:

    1. Remove the front propeller shaft (Click here).

    2. A271251
      Detach the 4 wire harness clamps.

    3. Disconnect the differential pressure sensor connector and detach the wire harness clamp.

    4. A271240
      Disconnect the No. 3 air hose and No. 4 air hose.

    5. Remove the bolt and sensor bracket.

    6. Remove the bolt and differential pressure sensor from the sensor bracket.

← ON-VEHICLE INSPECTION (from Jan 2012)INSTALLATION (from Jan 2012) →