DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| INITIAL CHECK |
The initial check occurs when the ignition switch is off for more than 2 seconds, and then turned to ON. The initial check consists of the pre-crash safety system diagnostic check which lasts approximately 3 seconds.
If a malfunction is detected during the initial check, the multi-information display displays "CHECK PCS SYSTEM" or "PCS TEMPORARILY NOT AVAILABLE".
Warning Message
Detail
DTC
PCS Warning Indicator
CHECK PCS SYSTEM
This message appears when the seat belt control ECU detects a system malfunction
DTC is output
ON
PCS TEMPORARILY NOT AVAILABLE
This message appears when the seat belt control ECU is in the fail-safe mode
DTC is not output
Blinking
| CONSTANT CHECK |
After completing the initial check, the pre-crash safety system will become operational. Then, the diagnosis circuit will perform a constant check to check that there is not a system malfunction.
If a malfunction is detected during the constant check, the multi-information display displays "CHECK PCS SYSTEM" or "PCS TEMPORARILY NOT AVAILABLE".

