2011-2013 Land Cruiser · Service Manual Vehicle Interior

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. REMOVE REAR SIDE NO. 2 AIR DUCT

E154788
  1. Remove the 3 screws and duct.


2. REMOVE REAR SIDE NO. 3 AIR DUCT

E154789
  1. Remove the 2 screws and duct.


3. REMOVE DRAIN COOLER HOSE

E154791
  1. Remove the screw.

  1. Detach the claw and remove the drain hose.


4. REMOVE REAR AIR MIX DAMPER SERVO SUB-ASSEMBLY

E154792
  1. Disconnect the connector.

  1. Remove the 2 screws and damper servo.


5. REMOVE REAR MODE DAMPER SERVO SUB-ASSEMBLY

E161096
  1. Remove the 2 screws and plate cover.

  1. E154793
    Disconnect the connector.

  1. Remove the 2 screws and damper servo.


6. REMOVE NO. 2 AIR MIX DAMPER SERVO SUB-ASSEMBLY

E154794
  1. Disconnect the connector.

  1. Remove the 2 screws and damper servo.


7. REMOVE AIR CONDITIONER ACCESSORY ASSEMBLY

E154795
  1. Remove the packing.

  1. E154335
    Remove the bolt and 4 screws.

  1. Using pliers, grip the claws of the clips and slide the 2 clips.

  1. Remove the air conditioner accessory assembly.

  1. Remove the 2 O-rings from the air conditioner accessory assembly.


8. REMOVE REAR COOLING UNIT EXPANSION VALVE

E154796
  1. Disconnect the connector.

  1. Detach the clamp.

  1. Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and expansion valve.


9. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY

E154797
  1. Remove the screw and detach the claw.

  1. Remove the heater clamp.

  1. E154798
    Remove the heater radiator.


10. REMOVE REAR BLOWER MOTOR

E154799
  1. Disconnect the connector.

  1. Remove the 3 screws and blower motor.


11. REMOVE BLOWER MOTOR CONTROLLER

E154812
  1. Disconnect the connector.

  1. Remove the 2 screws and blower motor controller.


12. REMOVE EVAPORATOR SUB-ASSEMBLY

E154800
  1. Remove the 12 screws and rear cooling unit case LH.

  1. Remove the evaporator.

  1. E131047
    Remove the 2 O-rings from the evaporator.


13. REMOVE REAR EVAPORATOR TEMPERATURE SENSOR

E154801
  1. Detach the 2 claws and remove the sensor.


14. REMOVE WIRING AIR CONDITIONING HARNESS SUB-ASSEMBLY
← REMOVAL (from Jan 2012)INSPECTION (from Sep 2011) →