2011-2013 Land Cruiser · Service Manual Vehicle Interior

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL WIRING AIR CONDITIONING HARNESS SUB-ASSEMBLY

2. INSTALL EVAPORATOR SUB-ASSEMBLY

E131047
  1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. Install the 2 O-rings to the evaporator.

  1. Install the evaporator.

  1. E154880
    Install the rear cooling unit case LH with the 12 screws.


3. INSTALL REAR BLOWER MOTOR

E154879
  1. Install the blower motor with the 3 screws.

  1. Connect the connector.


4. INSTALL BLOWER RESISTOR

E154878
  1. Install the blower resistor with the 2 screws.

  1. Connect the connector.


5. INSTALL REAR COOLING UNIT EXPANSION VALVE

E154877
  1. Using a 4 mm hexagon wrench, install the expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }

  1. Attach the clamp.

  1. Connect the connector.


6. INSTALL AIR CONDITIONER ACCESSORY ASSEMBLY

E154337
  1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. Install the 2 O-rings to the air conditioner accessory assembly.

  1. Install the air conditioner accessory assembly.

  1. Install the bolt and 2 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. E154874
    Install new packing as shown in the illustration.


7. INSTALL DRAIN COOLER HOSE

E154791
  1. Attach the claw to install the drain hose.

  1. Install the screw.


8. INSTALL REAR SIDE NO. 3 AIR DUCT

E154873
  1. Install the duct with the 2 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


9. INSTALL COOLING UNIT BRACKET

E154872
  1. Install the bracket with the 2 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← DISASSEMBLY (from Sep 2011)INSTALLATION (Sep 2011 – Dec 2011) →