2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REPAIR

Removal / installation · Vehicles built from Sep 2011


1. REPAIR DEFOGGER WIRE

B063722E13
Text in Illustration 
*1
Repair Point
*2
Broken Wire
*3
Masking Tape
  1. Clean the broken wire tips with grease, wax and silicone remover.

  1. Place masking tape along both sides of the wire.

  1. Thoroughly mix the repair agent.

    DuPont paste:
    No. 4817 or equivalent

  1. B063723E09
    Using a fine tip brush, apply a small amount of the agent to the wire.
    Text in Illustration 
    *1
    Repair Point
    *2
    Fine Tip Brush

  1. After a few minutes, remove the masking tape.

    NOTICE:
    Do not allow electricity to flow in the defogger wire for at least 24 hours.

← ON-VEHICLE INSPECTION (from Sep 2011)COMPONENTS (from Sep 2011) →