2011-2013 Land Cruiser · Service Manual Power Source / Network

DISASSEMBLY

Removal / installation · Vehicles built from Jan 2012


1. REMOVE GENERATOR PULLEY CAP

  1. A219656
    Using a screwdriver, remove the generator pulley cap.


2. REMOVE GENERATOR PULLEY WITH CLUTCH
  1. Mount the generator in a vise between aluminum plates.

  1. A219555E01
    Install SST (A) and SST (B) to the generator pulley with clutch as shown in the illustration.
    SST
    09820-63021  
    Text in Illustration 
    *1
    Rotor Shaft

    NOTICE:
    Securely attach SST to the generator pulley with clutch and rotor shaft.

  1. A219556E01
    Use a wrench to hold SST (A) and turn SST (B) counterclockwise to loosen the generator pulley with clutch.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    NOTICE:
    Be careful as the generator pulley with clutch or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

  1. Remove SST from the generator.

  1. Remove the generator pulley with clutch from the rotor shaft.


3. REMOVE GENERATOR REAR END COVER

  1. A221621
    Remove the nut and cord clip.

  1. A220458
    Remove the 3 nuts and generator rear end cover.


4. REMOVE TERMINAL INSULATOR

  1. A219659
    Remove the terminal insulator from the generator coil.


5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A219660
    Remove the 2 screws and brush holder from the generator coil.


6. REMOVE GENERATOR COIL ASSEMBLY

  1. A219661
    Remove the 4 bolts.

  1. A219662E01
    Using SST, remove the generator coil.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
    Text in Illustration 
    *a
    Hold
    V100135
    Turn


7. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A118365E01
    Remove the generator washer.

  1. A219665
    Remove the generator rotor.


8. INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A128080
    Check that the drive end frame bearing is not rough or worn.
    If necessary, replace the generator drive end frame bearing.


9. REMOVE GENERATOR DRIVE END FRAME BEARING

  1. A223426
    Remove the 4 screws and retainer plate from the generator drive end frame.

  1. A128077E01
    Using SST and a hammer, tap out the drive end frame bearing from the generator drive end frame.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

← REMOVAL (from Jan 2012)INSPECTION (from Jan 2012) →