INSPECTION
Inspection · Vehicles built from Jan 2012
| INSPECT GENERATOR PULLEY WITH CLUTCH |
Using SST, hold the center of the generator pulley with clutch and check that the outer ring turns counterclockwise and does not turn clockwise.

- SST
- 09820-63021
If the result is not as specified, replace the generator pulley with clutch.Text in Illustration *a
Hold


Free


Lock
| INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
Using a vernier caliper, measure the brush length.

- Standard exposed length:
- 9.5 to 11.5 mm (0.374 to 0.453 in.)
- Minimum exposed length:
- 4.5 mm (0.177 in.)
If the brush length is less than the minimum, replace the generator brush holder assembly.Text in Illustration *1
Length
| INSPECT GENERATOR ROTOR ASSEMBLY |
Check that the generator rotor bearing is not rough or worn.

If necessary, replace the generator rotor assembly.
Check the resistance.
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
Slip ring - Slip ring
20°C (68°F)
2.3 to 2.7 Ω
If the result is not as specified, replace the generator rotor assembly.Text in Illustration *1
Slip Ring
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
Slip ring - Rotor core
Always
10 MΩ or higher
If the result is not as specified, replace the generator rotor assembly.Text in Illustration *1
Slip Ring
*2
Rotor Core
Using a vernier caliper, measure the slip ring diameter.

- Standard diameter:
- 14.2 to 14.8 mm (0.559 to 0.583 in.)
- Minimum diameter:
- 14.0 mm (0.551 in.)
If the diameter is less than the minimum, replace the generator rotor assembly.Text in Illustration *1
Diameter
