Air Conditioning Amplifier Communication Stop Mode
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Air Conditioning Amplifier Communication Stop Mode |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
- CAUTION:
- For vehicles with an SRS system:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| NEXT | |
| 2. CHECK FOR OPEN IN CAN BUS WIRE (AIR CONDITIONING AMPLIFIER BRANCH WIRE) |
Disconnect the E35*1 or E81*2 air conditioning amplifier connector.

- HINT:
- *1: w/ Rear Air Conditioning System
- *2: w/o Rear Air Conditioning System
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
w/ Rear Air Conditioning System Tester Connection
Switch Condition
Specified Condition
E35-3 (CANH) - E35-4 (CANL)
Ignition switch off
54 to 69 Ω
w/o Rear Air Conditioning System Tester Connection
Switch Condition
Specified Condition
E81-11 (CANH) - E81-12 (CANL)
Ignition switch off
54 to 69 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND) |
Connect the cable to the negative (-) battery terminal.

- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Disconnect the E36*1 or E81*2 air conditioning amplifier connector.
- HINT:
- *1: w/ Rear Air Conditioning System
- *2: w/o Rear Air Conditioning System
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
w/ Rear Air Conditioning System Tester Connection
Condition
Specified Condition
E36-1 (GND) - Body ground
Always
Below 1 Ω
E36-2 (E1) - Body ground
Always
Below 1 Ω
w/o Rear Air Conditioning System Tester Connection
Condition
Specified Condition
E81-14 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
w/ Rear Air Conditioning System Tester Connection
Condition
Specified Condition
E36-6 (+B1) - Body ground
Always
11 to 14 V
E36-7 (+B2) - Body ground
Always
11 to 14 V
E36-5 (IG+) - Body ground
Ignition switch ON
11 to 14 V
w/o Rear Air Conditioning System Tester Connection
Condition
Specified Condition
E81-21 (+B1) - Body ground
Always
11 to 14 V
E81-1 (IG+) - Body ground
Ignition switch ON
11 to 14 V
|
|
||||
| OK | ||
| ||
