2011-2013 Land Cruiser · Service Manual Steering

B2782 Power Source Control ECU Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The steering lock ECU activates the steering lock motor by the power from the main body ECU through the IGE circuit. This prevents the steering from being locked while the vehicle is moving.
The diagnosis information of the steering lock ECU is transmitted to the intelligent tester via the certification ECU (smart key ECU assembly) as the steering lock ECU is not connected to the CAN communication system.
DTC Code
Detection Condition
Trouble Area
B2782
IGE power supply circuit malfunction
  1. Steering lock actuator assembly (steering lock ECU)
  2. Main body ECU
  3. Harness or connector

WIRING DIAGRAM

C165587E03

INSPECTION PROCEDURE

HINT:
When the engine switch is off, the main body ECU may occasionally go into a non-active state called sleep mode. Therefore, before proceeding with the inspection, it is necessary to perform the following steps to wake up the ECU:
With the engine switch off, open the driver door. Then (with the engine switch still off) open and close any door several times at 1.5 second intervals.


1. CHECK DTC OUTPUT (B2785)
  1. Check for DTCs (Click here).

    OK:
    DTC B2782 is output, but DTC B2785 is not output.



NG
GO TO LIN COMMUNICATION SYSTEM (B2785) (Click here)
OK


2. INSPECT STEERING LOCK ECU
C165193E08
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E26-3 (IGE) - E26-1 (GND)
    1. Engine switch on (IG)
    2. Steering lock motor is operating
    Below 1 V
    E26-3 (IGE) - E26-1 (GND)
    1. Engine switch on (IG)
    2. Steering lock motor is not operating
    11 to 14 V

    Result 
    Result
    Proceed to
    Within specified range (for Power tilt and telescopic)
    A
    Outside specified range
    B
    Within specified range (for Manual tilt and telescopic)
    C

    HINT:
    When the steering lock is activated and the engine switch is turned on (IG), the steering lock motor activates to release the steering lock. The motor operation occurs for 2 to 15 seconds.



B
Go to step 3

C
REPLACE STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) (Click here)
A

REPLACE STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) (Click here)

3. CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - MAIN BODY ECU AND BODY GROUND)
C164812E12
  1. Disconnect the E26 steering lock ECU connector.

  1. Disconnect the E1 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E26-3 (IGE) - E1-19 (SLR+)
    Always
    Below 1 Ω
    E26-1 (GND) - Body ground
    Always
    Below 1 Ω
    E26-3 (IGE) or E1-19 (SLR+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← B2781 Open / Short in Steering Lock ECU (from Jan 2012)B2782 Power Source Control ECU Malfunction (from Jan 2012) →