B2781 Open / Short in Steering Lock ECU
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The steering lock ECU and steering lock actuator assembly are supplied as a unit.The steering lock ECU detects the steering lock position through the signals from the lock and unlock position sensors.
The steering lock ECU activates the steering lock motor based on permission signals from the main body ECU and the certification ECU (smart key ECU assembly).
The diagnosis information of the steering lock ECU is transmitted to the intelligent tester via the certification ECU (smart key ECU assembly) as the steering lock ECU is not connected to the CAN communication system.
| DTC Code |
Detection Condition |
Trouble Area |
| B2781 |
When either condition below is met:
|
|
INSPECTION PROCEDURE
- HINT:
- When the engine switch is off, the main body ECU may occasionally go into a non-active state called sleep mode. Therefore, before proceeding with the inspection, it is necessary to perform the following steps to wake up the ECU:
- With the engine switch off, open the driver door. Then (with the engine switch still off) open and close any door several times at 1.5 second intervals.
| 1. CHECK DTC OUTPUT (B2785) |
Check for DTCs.
Result Result
Proceed to
DTC B2781 is output, but DTC B2785 is not output (for Power tilt and telescopic)
A
Condition other than following:
DTC B2781 is output, but DTC B2785 is not output
B
DTC B2781 is output, but DTC B2785 is not output (for Manual tilt and telescopic)
C
|
|
||||
|
|
||||
| A | ||
| ||
