2011-2013 Land Cruiser · Service Manual Steering

Unlock Position Sensor Signal Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The steering lock ECU sends an unlock position signal to the main body ECU. On receiving the signal, the main body ECU permits an engine start. This prevents the engine from being started with the steering locked.
The diagnosis information of the steering lock ECU is transmitted to the intelligent tester via the certification ECU (smart key ECU assembly) as the steering lock ECU is not connected to the CAN communication system.

WIRING DIAGRAM

C165587E05

INSPECTION PROCEDURE

HINT:
When the engine switch is off, the main body ECU may occasionally go into a non-active state called sleep mode. Therefore, before proceeding with the inspection, it is necessary to perform the following steps to wake up the ECU:
With the engine switch off, open the driver door. Then (with the engine switch still off) open and close any door several times at 1.5 second intervals.


1. INSPECT STEERING LOCK ECU
C165193E12
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition (Steering Lock Position)
    Specified Condition
    E26-4 (SLP1) - E26-2 (SGND)
    Locked
    11 to 14 V
    E26-4 (SLP1) - E26-2 (SGND)
    Unlocked
    Below 1 V



NG
Go to step 2
OK

GO TO ENTRY AND START SYSTEM (FOR START FUNCTION) (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - MAIN BODY ECU)
C164812E15
  1. Disconnect the E26 steering lock ECU connector.

  1. Disconnect the E1 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E26-4 (SLP1) - E1-18 (SLP)
    Always
    Below 1 Ω
    E26-4 (SLP1) or E1-18 (SLP) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    Within specified range (for Power tilt and telescopic)
    A
    Within specified range (for Manual tilt and telescopic)
    B
    Outside specified range
    C



B
REPLACE STEERING LOCK ACTUATOR (STEERING LOCK ECU) (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE STEERING LOCK ACTUATOR (STEERING LOCK ECU) (Click here)


← Steering Lock Motor Drive Power Circuit (from Jan 2012)Unlock Position Sensor Signal Circuit (from Jan 2012) →