B2780 Push Switch / Key Unlock Warning Switch Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON. Under normal conditions, the unlock warning switch assembly is on when the ignition switch is ON.| DTC Code |
DTC Detection Condition |
Trouble Area |
DTC Output Confirmation Operation |
| B2780 |
The unlock warning switch assembly is not detected as being on when the ignition switch is ON (1 trip detection logic*). |
|
Insert the key into the ignition key cylinder. |
- *: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected |
Fail-safe Operation when Malfunction Detected |
| Engine cannot be started |
- |
| DTC Code |
Data List and Active Test |
| B2780 |
Key SW |
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the transponder key ECU assembly, refer to the Service Bulletin.
- After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
- When replacing the transponder key ECU assembly, refer to the Service Bulletin.
| 1. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Check for DTCs (Click here).
- HINT:
- Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
- OK:
- DTC B2780 is not output.
|
|
||||
| OK | ||
| ||
| 3. INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
Inspect the unlock warning switch assembly (Click here).
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - TRANSPONDER KEY ECU ASSEMBLY AND BODY GROUND) |
Disconnect the E94 unlock warning switch assembly connector.
Disconnect the E96 transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E94-1 (UN+) - E96-3 (KSW)
Always
Below 1 Ω
E94-2 (UN-) - Body ground
Always
Below 1 Ω
E94-1 (UN+) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
