2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2780 Push Switch / Key Unlock Warning Switch Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON. Under normal conditions, the unlock warning switch assembly is on when the ignition switch is ON.
DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B2780
The unlock warning switch assembly is not detected as being on when the ignition switch is ON (1 trip detection logic*).
  1. Transponder key ECU assembly
  2. Unlock warning switch assembly
  3. Harness or connector
Insert the key into the ignition key cylinder.
  1. *: Only output while a malfunction is present.
Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started
-
Related Data List and Active Test 
DTC Code
Data List and Active Test
B2780
Key SW

WIRING DIAGRAM

B242195E13

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the transponder key ECU assembly, refer to the Service Bulletin.
  2. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.


1. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2. CHECK FOR DTC
  1. Check for DTCs (Click here).

    HINT:
    Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

    OK:
    DTC B2780 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)

3. INSPECT UNLOCK WARNING SWITCH ASSEMBLY
  1. Inspect the unlock warning switch assembly (Click here).



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - TRANSPONDER KEY ECU ASSEMBLY AND BODY GROUND)
  1. Disconnect the E94 unlock warning switch assembly connector.

  1. Disconnect the E96 transponder key ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E94-1 (UN+) - E96-3 (KSW)
    Always
    Below 1 Ω
    E94-2 (UN-) - Body ground
    Always
    Below 1 Ω
    E94-1 (UN+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY


← B2780 Push Switch / Key Unlock Warning Switch Malfunction (Sep 2011 – Dec 2011)B2784 Antenna Coil Open / Short (Sep 2011 – Dec 2011) →