Combination Meter ECU Communication Stop Mode
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Combination Meter ECU Communication Stop Mode |
Either condition is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND) |
Disconnect the E7 combination meter assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E7-15 (ET) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
E7-17 (B) - Body ground
Always
11 to 14 V
E7-18 (IG+) - Body ground
Ignition switch ON
11 to 14 V
| *a |
Front view of wire harness connector (to Combination Meter Assembly) |
| Result |
Proceed to |
| OK (w/ Multi-information Display) |
A |
| OK (w/o Multi-information Display) |
B |
| NG |
C |
|
|
||||
|
|
||||
| A | ||
| ||
