2011-2013 Land Cruiser · Service Manual Power Source / Network

Combination Meter ECU Communication Stop Mode

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

Detection Item
Symptom
Trouble Area
Combination Meter ECU Communication Stop Mode
  1. "Combination Meter" is not displayed on "Bus Check".
  2. "Combination Meter ECU Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside combination meter
  2. Combination meter

WIRING DIAGRAM

C175530E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)

  1. C170369E05
    Disconnect the E7 combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E7-15 (ET) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E7-17 (B) - Body ground
    Always
    11 to 14 V
    E7-18 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V

    Result 
    Result
    Proceed to
    OK (w/ Multi-information Display)
    A
    OK (w/o Multi-information Display)
    B
    NG
    C



B
REPLACE COMBINATION METER (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE COMBINATION METER (Click here)


← Main Body ECU Communication Stop Mode (from Jan 2012)Combination Meter ECU Communication Stop Mode (from Jan 2012) →