2011-2013 Land Cruiser · Service Manual Power Source / Network

Clearance Warning ECU Communication Stop Mode

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

Detection Item
DTC Detection Condition
Trouble Area
Clearance Warning ECU Communication Stop Mode
  1. "Clearance Warning (Clearance Sonar)" is not displayed on "Bus Check".
  2. "Clearance Warning ECU Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside clearance warning ECU
  2. Clearance warning ECU branch wire or connector
  3. Clearance warning ECU

WIRING DIAGRAM

E207358E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistance of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (CLEARANCE WARNING ECU BRANCH WIRE)
E207359E01
  1. Disconnect the F12 clearance warning ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    F12-3 (CANH) - F12-5 (CANL)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Clearance Warning ECU)



NG
REPAIR OR REPLACE CLEARANCE WARNING ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY AND BODY GROUND)

  1. E207359E02
    Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F12-17 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F12-15 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*1
Front view of wire harness connector
(to Clearance Warning ECU)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CLEARANCE WARNING ECU (Click here)


← Skid Control ECU Communication Stop Mode (from Jan 2012)Clearance Warning ECU Communication Stop Mode (from Jan 2012) →