2011-2013 Land Cruiser · Service Manual Vehicle Exterior

TERMINALS OF ECU

System information · Vehicles built from Sep 2011


CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
B160074E06
  1. Disconnect the R5 ECU connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R5-1 (B) - R5-2 (E)
    L - W-B
    +B power supply
    Always
    11 to 14 V
    R5-5 (IG) - R5-2 (E)
    G - W-B
    Power supply
    Engine switch off
    Below 1 V
    R5-5 (IG) - R5-2 (E)
    G - W-B
    Power supply
    Engine switch on (IG)
    11 to 14 V
    R5-7 (OPN) - R5-2 (E)
    P - W-B
    Sliding roof motor open
    OPEN switch off
    10 kΩ or higher
    R5-7 (OPN) - R5-2 (E)
    P - W-B
    Sliding roof motor open
    OPEN switch on
    Below 1 Ω
    R5-9 (CLS) - R5-2 (E)
    G - W-B
    Sliding roof motor close
    CLOSE switch off
    10 kΩ or higher
    R5-9 (CLS) - R5-2 (E)
    G - W-B
    Sliding roof motor close
    CLOSE switch on
    Below 1 Ω
    R5-10 (UP) - R5-2 (E)
    R - W-B
    Sliding roof motor up
    UP switch off
    10 kΩ or higher
    R5-10 (UP) - R5-2 (E)
    R - W-B
    Sliding roof motor up
    UP switch on
    Below 1 Ω
    R5-8 (DWN) - R5-2 (E)
    R - W-B
    Sliding roof motor down
    DOWN switch off
    10 kΩ or higher
    R5-8 (DWN) - R5-2 (E)
    R - W-B
    Sliding roof motor down
    DOWN switch on
    Below 1 Ω
    R5-2 (E) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1. If the result is not as specified, the ECU may have a malfunction.

← PROBLEM SYMPTOMS TABLE (from Sep 2011)DTC CHECK / CLEAR (from Sep 2011) →