2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


INSPECT V-RIBBED BELT

  1. A163879E01
    Check the belt for wear, cracks or other signs of damage.
    If any of the following defects is found, replace the V-ribbed belt.
    1. The belt is cracked.
    2. The belt is worn out to the extent that the cords are exposed.
    3. The belt has chunks missing from the ribs.

  1. Check that the belt fits properly in the ribbed grooves.

    HINT:
    Check with your hand to confirm that the belt has not slipped out of the groove on the bottom of the pulley.
    If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt.


INSPECT V-RIBBED BELT TENSION (w/ Viscous Heater)

  1. A177434
    Using a belt tension gauge, inspect the belt tension.

    Standard Belt Tension:
    Item
    Specified Condition
    New belt
    400 to 650 N (41 to 66 kgf, 89.9 to 146.1 lbf)
    Used belt
    300 to 500 N (31 to 51 kgf, 67.4 to 112.4 lbf)

    HINT:
    1. A "new belt" is a belt which has been used for less than 5 minutes on a running engine.
    2. A "used belt" is a belt which has been used on a running engine for 5 minutes or more.
    3. After installing a new belt, run the engine for approximately 5 minutes and then recheck the tension.


INSPECT V-RIBBED BELT TENSIONER ASSEMBLY

  1. A174846
    Check that nothing gets caught in the tensioner by turning it clockwise and counterclockwise.
    If a malfunction exists, replace the tensioner.

← COMPONENTS (from Jan 2012)ON-VEHICLE INSPECTION (from Jan 2012) →