Steering Pad Switch Circuit
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This circuit sends an operation signal from the steering pad switch to the radio receiver.If there is a short in the circuit, the resulting condition is the same as if the switch were continuously depressed.
WIRING DIAGRAM


INSPECTION PROCEDURE
- CAUTION:
- The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the Precaution for the SRS (Click here).
| 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - SPIRAL CABLE) |
Disconnect the F19 receiver connector.
Disconnect the E12 cable connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F19-8 (SW2) - E12-5 (AU2)
Always
Below 1 Ω
F19-6 (SWG) - E12-4 (EAU)
Always
Below 1 Ω
F19-7 (SW1) - E12-6 (AU1)
Always
Below 1 Ω
F19-8 (SW2) - Body ground
Always
10 kΩ or higher
F19-6 (SWG) - Body ground
Always
10 kΩ or higher
F19-7 (SW1) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. INSPECT SPIRAL CABLE SUB-ASSEMBLY |


| *a |
Steering Pad Switch Side |
*b |
Vehicle Side |
Disconnect the cable connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Spiral Cable Position
Specified Condition
E12-4 (EAU) - z36-8 (EAU)
2.5 rotations to the left
Below 3 Ω
Center
2.5 rotations to the right
E12-5 (AU2) - z36-9 (AU2)
2.5 rotations to the left
Below 3 Ω
Center
2.5 rotations to the right
E12-6 (AU1) - z36-10 (AU1)
2.5 rotations to the left
Below 3 Ω
Center
2.5 rotations to the right
- CAUTION:
- The spiral cable is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable may prevent the airbag from deploying. Be sure to read the Precaution for the SRS (Click here).
|
|
||||
| OK | |
| 3. INSPECT STEERING PAD SWITCH ASSEMBLY |
Disconnect the z36 switch connector.


| *1 |
Volume+ |
*2 |
Volume- |
| *3 |
Seek+ |
*4 |
Seek- |
| *5 |
MODE |
- |
- |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
10 (AU1) - 8 (EAU)
No switch is pushed
100 kΩ
Seek+ switch pushed
Below 2.5 Ω
Seek- switch pushed
329 Ω
Volume+ switch pushed
1000 Ω
Volume- switch pushed
3110 Ω
9 (AU2) - 8 (EAU)
No switch is pushed
100 kΩ
MODE switch pushed
Below 2.5 Ω
|
|
||||
| OK | ||
| ||
