The door control receiver receives signals from the transmitter and sends these signals to the main body ECU. The main body ECU then controls all the doors by sending lock/unlock signals to each door.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When replacing the door control receiver, refer to the registration procedures (Click here).
Move the transmitter in the vicinity of the door control receiver.
HINT:
Refer to Parts Location for the location of the door control receiver (Click here).
Press and hold either the lock or unlock transmitter switch for 1 second, and check that the doors are locked or unlocked accordingly.
OK:
Wireless door lock control functions operate normally.
HINT:
Check if electrical noise is the cause by moving the door control transmitter closer to the door control receiver. Moving closer will decrease the effects of electrical noise.
If the operation check can be performed normally, there is a high probability that electrical noise or a decrease in output from the door control transmitter is the cause of the malfunction. There is a high probability that electrical noise is the cause if the problem occurs only in a certain location or only during a certain time of day. Also, custom components may be causing electrical noise. If custom components are installed in the vehicle, remove them and perform the operation check again.