2011-2013 Land Cruiser · Service Manual Vehicle Interior

B1242 Wireless Door Lock Tuner Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Sep 2011

DESCRIPTION

The door control receiver receives signals from the transmitter and sends these signals to the main body ECU. This DTC is stored when the applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU.
DTC Code
DTC Detection Condition
Trouble Area
B1242
The applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU.
  1. Harness or connector
  2. Door control receiver
  3. Main body ECU (Cowl Side Junction Block LH)

WIRING DIAGRAM

B242194E04

INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. When replacing the door control receiver, refer to the registration procedures (Click here).


1. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2. CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B1242 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)

3. CHECK DOOR CONTROL RECEIVER (DOOR CONTROL RECEIVER - MAIN BODY ECU)
  1. Disconnect the L47 receiver connector.

  1. Disconnect the E2 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L47-2 (RDA) - E2-12 (RDA)
    Always
    Below 1 Ω
    L47-3 (PRG) - E2-10 (PRG)
    Always
    Below 1 Ω
    L47-2 (RDA) - Body ground
    Always
    10 kΩ or higher
    L47-3 (PRG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND)

  1. B219541E13
    Disconnect the L47 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L47-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L47-5 (+B) - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Door Control Receiver)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. REPLACE DOOR CONTROL RECEIVER
  1. Temporarily replace the door control receiver with a new one (Click here).

  1. Perform the registration procedures (Click here).


NEXT


6. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


7. CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B1242 is not output.



NG
REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
OK

END (DOOR CONTROL RECEIVER IS DEFECTIVE)


← DIAGNOSTIC TROUBLE CODE CHART (from Sep 2011)Only Wireless Control Function is Inoperative (Sep 2011 – Dec 2011) →