2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal of an external device to the multi-media interface ECU through this circuit.

WIRING DIAGRAM

E183263E46

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER)
  1. Disconnect the L45 multi-media interface ECU connector.

  1. Disconnect the m1 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    m1-3 (UDI+) - L45-3 (UDI+)
    Always
    Below 1 Ω
    m1-2 (UDI-) - L45-2 (UDI-)
    Always
    Below 1 Ω
    m1-3 (UDI+) - Body ground
    Always
    10 kΩ or higher
    m1-2 (UDI-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (from Jan 2012)Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter (from Jan 2012) →