Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The No. 1 stereo jack adapter assembly sends sound signal from an external device to the radio receiver assembly through this circuit.The sound signal that has been sent is amplified by the stereo component amplifier assembly or radio receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly or speakers.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the m1 No. 1 stereo jack adapter assembly and F19 radio receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
m1-8 (AUXO) - F19-19 (AUXI)
Always
Below 1 Ω
m1-7 (ASGN) - F19-16 (ASGN)
Always
Below 1 Ω
m1-5 (ARO) - F19-15 (ARI)
Always
Below 1 Ω
m1-6 (ALO) - F19-17 (ALI)
Always
Below 1 Ω
m1-9 (AGND) - F19-18 (AGND)
Always
Below 1 Ω
m1-8 (AUXO) - Body ground
Always
10 kΩ or higher
m1-7 (ASGN) - Body ground
Always
10 kΩ or higher
m1-5 (ARO) - Body ground
Always
10 kΩ or higher
m1-6 (ALO) - Body ground
Always
10 kΩ or higher
m1-9 (AGND) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
