2011-2013 Land Cruiser · Service Manual Vehicle Exterior

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

This circuit supplies power to operate the power back door unit assembly (power back door ECU).

WIRING DIAGRAM

B312266E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU] - BATTERY AND BODY GROUND)
B122460E57
  1. Disconnect the power back door unit assembly (power back door ECU) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L52-10 (ECUB) - Body ground
    Always
    11 to 14 V
    L52-12 (B) - Body ground
    Always
    11 to 14 V
    L52-8 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V
    L52-8 (IG) - Body ground
    Engine switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L52-11 (GND) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Power Back Door Unit Assembly [Power Back Door ECU])


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Door Control Switch Circuit (from Jan 2012)Power Back Door Sensor Circuit (from Jan 2012) →