Door Control Switch Circuit
Circuit diagnosis · Vehicles built from Jan 2012
DESCRIPTION
The back door control switch only turns on while the switch is being pressed, and turns off when the back door control switch is released.When the back door control switch is on, a power back door close request signal is input to the power back door unit assembly (power back door ECU) to close the back door.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (PBD CLOSE SW) |
Check the Data List for proper functioning of the back door control switch (Click here).
Back Door Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
PBD Close SW
Back door control switch signal / ON or OFF
ON: Back door control switch on
OFF: Back door control switch off
-
- OK:
- The display is as specified in the normal condition.
|
|
||||
| OK | ||
| ||
| 2. INSPECT BACK DOOR CONTROL SWITCH |
Remove the back door control switch (Click here).
Inspect the back door control switch (Click here).
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (BACK DOOR CONTROL SWITCH - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU] AND BODY GROUND) |
Disconnect the S25 back door control switch connector.
Disconnect the L52 power back door unit assembly (power back door ECU) connector.
Measure the resistance of the wire harness side connectors.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
S25-3 (MSW) - L52-4 (DS1)
Always
Below 1 Ω
S25-4 (E) - Body ground
Always
Below 1 Ω
S25-3 (MSW) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
