2011-2013 Land Cruiser · Service Manual Drivetrain

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. REMOVE REAR AXLE SHAFT SNAP RING

  1. C159455
    Using a snap ring expander, remove the snap ring.


2. REMOVE REAR AXLE SHAFT LH

  1. C159456E01
    Using SST and a press, press out the rear axle shaft.
    SST
    09521-25011  
    09521-60010  

  1. Remove the rear axle bearing inner retainer from the axle hub.

  1. Remove the rear axle shaft washer from the axle hub.

  1. F042797
    Grind the rear axle bearing inner race surface using a grinder, then remove it with a chisel.


3. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH

  1. C159457
    Temporarily install 4 nuts to the housing bolts.

    NOTICE:
    Do not use any nuts removed from the vehicle, as they may be damaged.

  1. Using a hammer, remove the 4 housing bolts and rear axle hub and bearing.

  1. Remove the 4 nuts.


4. REMOVE BRAKE DRUM OIL DEFLECTOR LH

  1. C159721E01
    Using SST, remove the 5 hub bolts.
    SST
    09650-17011  

    NOTICE:
    1. Do not deform the oil deflector.
    2. Make sure to align the notch of SST with the flange of the oil deflector.

  1. Remove the deflector and deflector gasket from the rear axle shaft.

← REMOVAL (from Sep 2011)INSPECTION (from Sep 2011) →