DATA LIST / ACTIVE TEST
System information · Vehicles built from Jan 2012
| DATA LIST |
- HINT:
- Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / PPS / Data List.
According to the display on the GTS, read the Data List.
PPSĀ Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Steering Angle Velocity
Steering angle speed/
Min.: -32768 deg/s
Max.: 32767 deg/s
Value changes in proportion to steering effort
The engine is running and the steering wheel is being turned.
Meter Vehicle Velocity
Vehicle speed from meter/
Min.: 0.00 km/h (0.00 mph)
Max.: 300.00 km/h (186.41 mph)
0 km/h (0 mph)
The vehicle is stopped.
No large fluctuation
The vehicle is driven at a constant speed.
Engine Revolution
Engine speed/
Min.: 0 rpm
Max.: 12800 rpm
No large fluctuation
The engine is running at a constant speed.
Steering Angle
Steering angle/
Min.: -2048.0 deg
Max.: 2047.0 deg
Left turn: Increases
Right turn: Decreases
The engine is running and the steering wheel is being turned.
Solenoid Current
Solenoid Current/
Min.: 0 mA
Max.: 1000 mA
200 to 950 mA
The engine is running and the steering wheel is being turned.
IG Power Supply
ECU power source voltage/
Min.: 0.0 V
Max.: 25.5 V
11 to 14 V
The engine switch is on (IG)
The Number of DTCs
Number of DTCs/
Min.: 0
Max.: 255
0
-