2011-2013 Land Cruiser · Service Manual Vehicle Exterior

B2313 Glass Position Initialization Incomplete

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The power window regulator motor assembly is driven by operating the power window switch. The power window regulator motor assembly has motor, regulator and ECU functions.
When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.

HINT:
This DTC may be stored for all the windows.

NOTICE:
  1. When the power window regulator motor is reinstalled or replaced, the power window control system must be initialized.
  2. After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:
    1. Close the power window by fully pulling up the power window switch and holding it in the auto up position.
    2. Open the power window by fully pushing down the switch.

DTC Code
DTC Detection Condition
Trouble Area
B2313
  1. The power window regulator motor is not initialized.
  2. The power window regulator motor malfunctions.
  1. Front power window regulator motor assembly LH (for LHD)
  2. Front power window regulator motor assembly RH (for RHD)

INSPECTION PROCEDURE


1. PERFORM INITIALIZATION (APPLICABLE LOCATION)
  1. Initialize the power window regulator motor (Click here).


NEXT


2. CHECK FOR DTC
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    B2313 is not output
    A
    B2313 output from front power window regulator motor LH (for LHD)
    B
    B2313 output from front power window regulator motor RH (for RHD)
    C



B
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (Click here)

C
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (Click here)
A

END


← B2313 Glass Position Initialization Incomplete (Sep 2011 – Dec 2011)Remote Up / Down Function does not Operate (Sep 2011 – Dec 2011) →