DATA LIST / ACTIVE TEST
System information · Vehicles built from Sep 2011
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
According to the display on the intelligent tester, read the Data List.
Master Switch Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
D Door P/W Auto SW
Driver side power window auto up/down signal / ON or OFF
ON: Driver side power window auto up/down switch on multiplex network master switch operated
OFF: Driver side power window switch on multiplex network master switch not operated
-
P Door P/W Auto SW
Front passenger side power window remote auto up/down signal / ON or OFF
ON: Front passenger side power window remote auto up/down switch on multiplex network master switch operated
OFF: Front passenger side power window switch on multiplex network master switch not operated
-
RR Door P/W Auto SW
Rear power window RH remote auto up/down signal / ON or OFF
ON: Rear power window RH remote auto up/down switch on multiplex network master switch operated
OFF: Rear power window switch RH on multiplex network master switch not operated
-
RL Door P/W Auto SW
Rear power window LH remote auto up/down signal / ON or OFF
ON: Rear power window LH remote auto up/down switch on multiplex network master switch operated
OFF: Rear power window switch LH on multiplex network master switch not operated
-
P Door P/W Up SW
Front passenger side power window remote manual up signal / ON or OFF
ON: Front passenger side power window remote manual up switch on multiplex network master switch operated
OFF: Front passenger side power window switch on multiplex network master switch not operated
-
RR Door P/W up switch
Rear power window RH remote manual up signal / ON or OFF
ON: Rear power window RH remote manual up switch on multiplex network master switch operated
OFF: Rear power window switch RH on multiplex network master switch not operated
-
RL Door P/W up switch
Rear power window LH remote manual up signal / ON or OFF
ON: Rear power window LH remote manual up switch on multiplex network master switch operated
OFF: Rear power window switch LH on multiplex network master switch not operated
-
P Door P/W Down SW
Front passenger side power window remote manual down signal / ON or OFF
ON: Front passenger side power window remote manual down switch on multiplex network master switch operated
OFF: Front passenger side power window switch on multiplex network master switch not operated
-
RR Door P/W Down SW
Rear power window RH remote manual down signal / ON or OFF
ON: Rear power window RH remote manual down switch on multiplex network master switch operated
OFF: Rear power window switch RH on multiplex network master switch not operated
-
RL Door P/W Down SW
Rear power window LH remote manual down signal / ON or OFF
ON: Rear power window LH remote manual down switch on multiplex network master switch operated
OFF: Rear power window switch LH on multiplex network master switch not operated
-
Window Lock Switch Status
Power window lock switch / ON or OFF
ON: Power window lock switch on
OFF: Power window lock switch off
-
Number of Trouble Codes
Number of trouble codes / Min.: 0, Max.: 255
Number of DTCs will be displayed
-
D-Door Motor Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
D Door P/W Auto SW
Driver side power window auto up/down signal / ON or OFF
ON: Driver side power window auto up/down switch operated
OFF: Driver side power window switch not operated
-
D Door P/W Up SW
Driver side power window manual up signal / ON or OFF
ON: Driver side power window manual up switch operated
OFF: Driver side power window switch not operated
-
D Door P/W Down SW
Driver side power window manual down signal / ON or OFF
ON: Driver side power window manual down switch operated
OFF: Driver side power window switch not operated
-
Glass Position (Close-1/4)
Jam protection status of window glass within range of fully closed to 1/4 open position / OK or Caution
OK: Motor normally operates between fully closed to 1/4 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (1/4-2/4)
Jam protection status of window glass within range of 1/4 to 1/2 open position / OK or Caution
OK: Motor normally operates between 1/4 to 1/2 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (2/4-3/4)
Jam protection status of window glass within range of 1/2 to 3/4 open position / OK or Caution
OK: Motor normally operates between 1/2 to 3/4 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (3/4-Open)
Jam protection status of window glass within range of 3/4 to fully open position / OK or Caution
OK: Motor normally operates between 3/4 to fully open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Number of Trouble Codes
Number of trouble codes / Min.: 0, Max.: 255
Number of DTCs will displayed
-
P-Door Motor Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
P Door P/W Auto SW
Front passenger side power window auto up/down signal / ON or OFF
ON: Front passenger side power window auto up/down switch operated
OFF: Front passenger side power window regulator switch not operated
-
P Door P/W Up SW
Front passenger side power window manual up signal / ON or OFF
ON: Front passenger side power window manual up switch operated
OFF: Front passenger side power window regulator switch not operated
-
P Door P/W Down SW
Front passenger side power window manual down signal / ON or OFF
ON: Front passenger side power window manual down switch operated
OFF: Front passenger side power window regulator switch not operated
-
Glass Position (Close-1/4)
Jam protection status of window glass within range of fully closed to 1/4 open position / OK or Caution
OK: Motor normally operates between fully closed to 1/4 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (1/4-2/4)
Jam protection status of window glass within range of 1/4 to 1/2 open position / OK or Caution
OK: Motor normally operates between 1/4 to 1/2 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (2/4-3/4)
Jam protection status of window glass within range of 1/2 to 3/4 open position / OK or Caution
OK: Motor normally operates between 1/2 to 3/4 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (3/4-Open)
Jam protection status of window glass within range of 3/4 to fully open position / OK or Caution
OK: Motor normally operates between 3/4 to fully open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Number of Trouble Codes
Number of trouble codes / Min.: 0, Max.: 255
Number of DTCs will be displayed
-
RL-Door Motor Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
RL Door P/W Auto SW
Rear power window LH auto up/down signal / ON or OFF
ON: Rear power window LH auto up/down switch operated
OFF: Rear power window LH switch not operated
-
RL Door P/W Up SW
Rear power window LH manual up signal / ON or OFF
ON: Rear power window LH manual up switch operated
OFF: Rear power window LH switch not operated
-
RL Door P/W Down SW
Rear power window LH manual down signal / ON or OFF
ON: Rear power window LH manual down switch operated
OFF: Rear power window LH switch not operated
-
Glass Position (Close-1/4)
Jam protection status of window glass within range of fully closed to 1/4 open position / OK or Caution
OK: Motor normally operates between fully closed to 1/4 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (1/4-2/4)
Jam protection status of window glass within range of 1/4 to 1/2 open position / OK or Caution
OK: Motor normally operates between 1/4 to 1/2 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (2/4-3/4)
Jam protection status of window glass within range of 1/2 to 3/4 open position / OK or Caution
OK: Motor normally operates between 1/2 to 3/4 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (3/4-Open)
Jam protection status of window glass within range of 3/4 to fully open position / OK or Caution
OK: Motor normally operates between 3/4 to fully open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Number of Trouble Codes
Number of trouble codes / Min.: 0, Max.: 255
Number of DTCs will be displayed
-
RR-Door Motor Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
RR Door P/W Auto SW
Rear power window RH auto up/down signal / ON or OFF
ON: Rear power window RH auto up/down switch operated
OFF: Rear power window RH switch not operated
-
RR Door P/W Up SW
Rear power window RH manual up signal / ON or OFF
ON: Rear power window RH manual up switch operated
OFF: Rear power window RH switch not operated
-
RR Door P/W Down SW
Rear power window RH manual down signal / ON or OFF
ON: Rear power window RH manual down switch operated
OFF: Rear power window RH switch not operated
-
Glass Position (Close-1/4)
Jam protection status of window glass within range of fully closed to 1/4 open position / OK or Caution
OK: Motor normally operates between fully closed to 1/4 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (1/4-2/4)
Jam protection status of window glass within range of 1/4 to 1/2 open position / OK or Caution
OK: Motor normally operates between 1/4 to 1/2 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (2/4-3/4)
Jam protection status of window glass within range of 1/2 to 3/4 open position / OK or Caution
OK: Motor normally operates between 1/2 to 3/4 open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Glass Position (3/4-Open)
Jam protection status of window glass within range of 3/4 to fully open position / OK or Caution
OK: Motor normally operates between 3/4 to fully open position
Caution: Jam protection function operates due to detection of foreign object or irregular movement
-
Number of Trouble Codes
Number of trouble codes / Min.: 0, Max.: 255
Number of DTCs will be displayed
-
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Communication D-Door Motor
Connection status between power window regulator motor (for driver side) and main body ECU / OK or Stop
OK: Connection
Stop: No connection
-
Communication P-Door Motor
Connection status between power window regulator motor (for front passenger side) and main body ECU / OK or Stop
OK: Connection
Stop: No connection
-
Communication RR-Door Motor
Connection status between rear power window regulator motor LH and main body ECU / OK or Stop
OK: Connection
Stop: No connection
-
Communication RL-Door Motor
Connection status between rear power window regulator motor RH and main body ECU / OK or Stop
OK: Connection
Stop: No connection
-
Communication Master SW
Connection status between master switch and main body ECU / OK or Stop
OK: Connection
Stop: No connection
-
D Door Courtesy SW
Driver side door courtesy signal / ON or OFF
ON: Driver door open
OFF: Driver door closed
-
P Door Courtesy SW
Front passenger side door courtesy signal / ON or OFF
ON: Front passenger door open
OFF: Front passenger door closed
-
RL Door Courtesy SW
Rear LH side door courtesy signal / ON or OFF
ON: Rear LH side door open
OFF: Rear LH side door closed
-
RR Door Courtesy SW
Rear RH side door courtesy signal / ON or OFF
ON: Rear RH side door open
OFF: Rear RH side door closed
-
| PERFORM ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Active Test.
According to the display on the intelligent tester, perform the Active Test.
- CAUTION:
- Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function does not operate.
D-Door Motor Tester Display
Test Part
Control Range
Diagnostic Note
Power Window
Driver side power window
OFF/UP/DOWN
-
P-Door Motor Tester Display
Test Part
Control Range
Diagnostic Note
Power Window
Front passenger side power window
OFF/UP/DOWN
-
RL-Door Motor Tester Display
Test Part
Control Range
Diagnostic Note
Power Window
Rear LH side power window
OFF/UP/DOWN
-
RR-Door Motor Tester Display
Test Part
Control Range
Diagnostic Note
Power Window
Rear RH side power window
OFF/UP/DOWN
-