2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

B180991
  1. Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

HINT:
Use the same procedures described for the LH side.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A178461
    Remove the 10 bolts and under cover.


4. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }


    A174296E01

  1. Tighten the radiator drain cock plug by hand.


5. REMOVE V-BANK COVER

  1. A174196E03
    Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Bracket
    *2
    Hook
    *3
    Pin
    *4
    Grommet


6. REMOVE NO. 2 AIR CLEANER HOSE

  1. A178932
    Loosen the 2 hose clamps and remove the air cleaner hose.


7. REMOVE AIR CLEANER ASSEMBLY

  1. A151812
    Disconnect the No. 2 ventilation hose.

  1. Detach the hose clamp.

  1. A185261
    Disconnect the vacuum hose.

  1. Disconnect the MAF meter connector.

  1. Using a clip remover, detach the 2 wire harness clamps.

  1. A151770
    Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner assembly.


8. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

  1. A075597E01
    Disconnect the No. 5 water by-pass hose.

  1. A075598E01
    Disconnect the No. 4 water by-pass hose.

  1. A075599E01
    Disconnect the throttle position sensor and throttle control motor connector.

  1. Remove the 4 bolts, then remove the throttle body with motor and gasket.


9. REMOVE VVT SENSOR (for Bank 1)

  1. A176575
    Disconnect the sensor connector.

  1. Remove the bolt and sensor.


10. REMOVE VVT SENSOR (for Bank 2)

  1. A176576
    Disconnect the sensor connector.

  1. Remove the bolt and sensor.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →