INSTALLATION
Removal / installation · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. INSTALL CRANKSHAFT POSITION SENSOR |
Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
- NOTICE:
- When reusing the sensor, inspect the O-ring.
- If the O-ring has scratches or cuts, replace the crankshaft position sensor.
- When reusing the sensor, inspect the O-ring.
Install the crankshaft position sensor with the bolt.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
Connect the sensor connector.
| 2. INSTALL COOLER COMPRESSOR ASSEMBLY |
| 3. INSTALL GENERATOR ASSEMBLY |
- for 100 A Type (Click here)
- for 130 A Type (Click here)
