2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL KNOCK SENSOR

  1. A078438E13
    Install the 2 sensors with the 2 bolts as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the 2 sensor connectors.


2. INSTALL NO. 1 WATER OUTLET PIPE

A178539
  1. for 2 Nuts and Bolt Type
    Install the water outlet pipe with the 2 nuts and bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. for 3 Bolts Type
    Install the water outlet pipe with the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the 4 wire harness clamps.


3. INSTALL CYLINDER HEAD SUB-ASSEMBLY RH (for Bank 1)
  1. Install the cylinder head RH (Click here).


4. INSTALL ENGINE ASSEMBLY
  1. Install the engine (Click here).


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← INSPECTION (from Sep 2011)INSTALLATION (from Jan 2012) →