2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011


INSPECT FUEL PUMP

A158976E03
  1. Inspect the resistance of the fuel pump.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      0.2 to 3.0 Ω

      If the result is not as specified, replace the fuel suction with pump and gauge tube.

  1. A181451E01
    Inspect the operation of the fuel pump.

    1. Connect the battery's positive (+) lead to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.
      If the result is not as specified, replace the fuel pump and fuel pump ECU.

      NOTICE:
      1. These tests must be performed within 10 seconds to prevent the coil from burning out.
      1. Keep the fuel pump as far away from the battery as possible.
      1. Always turn the voltage on and off on the battery side, not the fuel pump side.
      2. When the pump is locked and does not operate due to foreign matter being stuck, etc., replace the fuel pump ECU together with the fuel pump, as the fuel pump ECU may be damaged electrically.

← DISASSEMBLY (Sep 2011 – Dec 2011)REASSEMBLY (Sep 2011 – Dec 2011) →