2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

DISASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011


NOTICE:
A181362
Do not disconnect the hoses indicated in the illustration.


1. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A181432
    Disconnect the fuel sender gauge connector.

  1. A175037E01
    Press down on the sender gauge claw labeled A. Then slide the sender gauge upward to remove it.


2. REMOVE NO. 1 FUEL SUB-TANK

  1. A181430
    Disconnect the fuel pump connector.

  1. A176342E01
    Disconnect the jet pump (labeled A) from the sub-tank.

  1. Disconnect the jet pump (labeled B) from the sub-tank.

    1. Using a small screwdriver, detach the claw from the sub-tank.

      HINT:
      Tape the screwdriver tip before use.

  1. A176344
    Using a screwdriver, detach the 3 claws from the claw holes.

    NOTICE:
    Do not damage the fuel sub-tank.

    HINT:
    Tape the screwdriver tip before use.

  1. A175041
    Using a screwdriver, detach the 3 claws from the claw holes.

    NOTICE:
    Do not damage the fuel sub-tank.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE FUEL PUMP

  1. A176388E01
    Using a screwdriver, detach the 5 claws from the claw holes and disconnect the fuel pump from the fuel filter case.

    HINT:
    Tape the screwdriver tip before use.

  1. A175042
    Disconnect the fuel pump wire harness connector from the fuel pump to remove it.

  1. A175043E01
    Remove the O-ring and spacer from the fuel pump.


4. REMOVE FUEL MAIN VALVE ASSEMBLY

  1. A175044E01
    Remove the fuel main valve from the fuel filter case.

  1. Remove the 2 O-rings from the fuel main valve.


5. REMOVE NO. 1 FUEL SUCTION SUPPORT

  1. A175045
    Detach the 2 claws from the claw holes to remove the fuel suction support.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →