2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. INSTALL OIL PUMP ROTOR SET

  1. A150121E02
    Apply engine oil to the oil pump rotor set.

  1. Place the drive and driven rotors into the pump body with the marks facing the oil pump cover side.


2. INSTALL OIL PUMP COVER

  1. A150119
    Install the oil pump cover with the 10 screws.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


3. INSTALL OIL PUMP RELIEF VALVE

  1. A160767
    Insert the relief valve and compression spring into the oil pump body hole.

  1. Install the relief valve plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


4. INSTALL OIL PUMP SEAL

  1. A134819E02
    Using SST and a hammer, tap in a new oil seal until its surface is flush with the oil pump body edge.
    SST
    09316-60011   (09316-00011)

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap the oil seal at an angle.

  1. Apply MP grease to the lip of the oil seal.

    NOTICE:
    1. Do not allow foreign matter to contact the lip.
    2. Do not allow MP grease to contact the dust seal.

← INSPECTION (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →