2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE FRONT BUMPER COVER (for Standard)
(Click here)

2. REMOVE FRONT BUMPER COVER (w/ Winch)
(Click here)

3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A178461
    Remove the 10 bolts and No. 1 engine under cover.


4. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


A274035E01
Text in Illustration 
*1
Radiator Reservoir
*2
Radiator Cap
*3
Radiator Drain Cock Plug
*4
Cylinder Block Water Drain Cock Plug
*a
for Type A
*b
for Type B
  1. for Type A:
    Loosen the radiator drain cock plug and 2 cylinder block water drain cock plugs.

  1. for Type B:
    Loosen the radiator drain cock plug and cylinder block water drain cock plug.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. for Type A:
    Tighten the 2 cylinder block water drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. for Type B:
    Tighten the cylinder block water drain cock plug.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Tighten the radiator drain cock plug by hand.


5. REMOVE V-BANK COVER

  1. A267633E01
    Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Pin
    *2
    Hook


6. REMOVE TRANSMISSION OIL COOLER AIR DUCT (w/ Air Cooled Transmission Oil Cooler)

  1. A266155
    Remove the 4 bolts and oil cooler air duct.


7. REMOVE RADIATOR SIDE DEFLECTOR RH (w/o Air Cooled Transmission Oil Cooler)

  1. A266156
    Using a clip remover, remove the 4 clips and move the side deflector so that the radiator can be removed in a later step.


8. REMOVE RADIATOR SIDE DEFLECTOR LH

  1. A266157
    Using a clip remover, remove the 4 clips and move the side deflector so that the radiator can be removed in a later step.


9. REMOVE NO. 1 RADIATOR HOSE

10. REMOVE NO. 2 RADIATOR HOSE

  1. A273588
    Detach the clamp and remove the No. 2 radiator hose.


11. DISCONNECT OIL COOLER TUBE (w/ Air Cooled Transmission Oil Cooler)

  1. A266158
    Detach the claw to open the flexible hose clamp, and then remove the 2 bolts to disconnect the oil cooler tube from the fan shroud.


12. REMOVE FAN SHROUD
  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the fan and generator V-belt (Click here).

  1. A273614
    Disconnect the reservoir hose from the upper side of the radiator tank.

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.


13. DISCONNECT INLET OIL COOLER HOSE (for Automatic Transmission)

  1. A266159
    Disconnect the oil cooler hose.


14. DISCONNECT OUTLET OIL COOLER HOSE (for Automatic Transmission)
  1. Disconnect the oil cooler hose.


15. REMOVE RADIATOR ASSEMBLY

  1. A174323
    Remove the 4 bolts and radiator.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →